The MOVEO 24V 10A FLX L is mainly used in security systems where an SSF 1014* approved battery backup is required or where the requirements are more valid; higher flexibility, more alarm functions, longer back-up times or when the battery backup needs to handle higher loads. The MOVEO 24V 10A FLX L is SSF1014 certified with Integra. The MOVEO 24V 10A FLX L offers communication via RS232 against Integra MOVEO & MOVEO XL. RS232 card & 3 meter cable for communication between battery backup and central included as well as fuse card 2+2 output module. The MOVEO 24V 10A FLX L reads the connected system load and charges the batteries with available residual power from the power supply, but never charges the batteries by more than maximum 4A (applies to FLX S) in charge current. This prevents the batteries from overcharging and significantly extends their life span. The MOVEO 24V 10A FLX L is also equipped with internal power resistors (customized for system-tested battery) for qualified battery capacity testing, which notifies when batteries need to be replaced before batteries age. MOVEO 24V 10A FLX L is system certified together with / & to be used together with UPLUS 10+ Design Life AGM batteries according to SSF1014, 2x 45Ah batteries are included. The MOVEO 24V 10A FLX L offers intelligent charging which means that when the batteries are fully charged they will be electronically disconnected for standby mode for up to 20 days or when the batteries have reached 26.7V. By discharging the batteries and having them recharged continuously (instead of being unused), the system extends the battery life by up to 50%. The batteries automatically connect in less than 50 microseconds, if needed. The MOVEO 24V 10A FLX L shall be mounted on a wall or in a 19″ rack (reversible angles included). The MOVEO 24V 10A FLX L can be supplemented with up to 1 battery box. The battery box is connected via a 9-pin connector. The battery box can hold up to 2x 45Ah batteries. *Note that the battery backup should be system certified with the parent system for SSF1014 certificate to be valid.
MOVEO 24V 10A FLX L
SSF1014 Approved battery backup 24V 10 (A) Amps including 2x 45Ah batteries (possible to expand with 1 battery box for up to 90Ah battery capacity), RS232 cable for communication with MOVEO / MOVEO XL and 1x fuse card 2+2 output module. Wall or rack mounted.
| Recommended environment | Indoor, class 1. Ambient temperature: +5°C to +40°C. For optimal battery life: +15°C to +25°C. |
|---|---|
| Security class (IP-klass) | |
| Recommended mounting | 19" rack, Wall |
| Height units | 10RU |
| Dimensioner (Höjd x Bredd x Djup) | 444 x 437 x 212 mm |
| Net weight | |
| Number of cable ports | 4, possible to have outlet holes on rear |
| Color | |
| Built in cooling fan | Yes |
| Voltage in (V) | 230 – 240 VAC, 50-60 Hz |
| Current out | 27.3 VDC (24 V) |
| Max current | |
| Available charging current (A) | Dependent upon power outlet, though max 6 A |
| Rated power | 240 W |
| Ripple i normal mode | 200 mVp-p |
| Efficiency | |
| heat generation at 50% / 80% of rated power | 17 W / 27 W |
| Current in (A) | 2 A |
| Number of unsecured (load-) outputs | |
| Type of fuse / ouput | 2 F10A (glass), 4x F2A (glass) |
| Deep discharge of battery occurs at | 21 VDC |
| Battery type | 12 V maintenance free AGM battery |
| Recommended battery | 2 UPLUS 12 V, 45 Ah batteries |
| Batteries included | Yes |
| Protection against | Deep discharge of batteries, Excessive temperature, Over voltage, Overload, Short circuit |
| Alarm via | RS232 |
| Alarm functions | Battery disconnected (10 sec), Charger error overvoltage, Charger error undervoltage, Delayed power grid failure alarm (10 sec), External alarm via pin list (optional card), Fuse failure, Low battery voltage, Low system voltage, Old battery, Tampering |
| Number of alarm outputs | Alarm via communication with MOVEO / MOVEO XL |
| Information via protocol | Alarm for high / low temperature, Alarm from temperature sensor, All standard alarm functions, Fan error, Forced battery test, Highest and lowest battery voltage since start, Highest and lowest temperature since start, Minimum / Max / Average temperature the latest hour / 72 hours, Minimum / Max / Average voltage the latest / 1 hour / 24 hours / 72 hours, Minimum / Max / Average voltage the latest 1 hour / 72 hours, Operational time in event of power outage, Possibility to set alarm levels |
| Tamper switch | Yes |
| Lockable enclosure | Yes, two keys included. |
| Number of optional cards that can be placed | Three L-module option, Two 10 output module |
| In-stock article | Yes |
| Normal dlivery time | |
| Guarantee period | 5 years (special warranty conditions apply) |
| Warranty conditions 5 year warranty | Average load shall not exceed 80 % of power supply's rated capacity-, Battery backup shall be used together with UPLUS 10+ Design Life batteries., Surrounding temperature shall not exceed 32°C., The fan shall be cleaned annually and replaced if needed. |
| Certified in accordance with | Meets requirements of alarm class 4, SSF 1014, edition 5, SSF1014 |
| Certificate number (SBSC) | 20-117 |
| Product meets requirements in accordance with | CE directive in accordance with:765/2008, EMC Directive 2014/30EU, Emission: EN61000-6-:2001, EN55022:1998:-A1:2000, A2:2003 Class B, EN61000-3-2:2001, Immunity: EN61000-6-2:2005, EN61000-4-2, -3, 4, -5, -6, -11. SS-EN 50 130-4:2011 Edition 2 & SSF1014 Alarm class 1-4 (Burgler alarm)., Low voltage directive: 2014/35/EU |
| Producer | Milleteknik AB |
| Country of origin |
Product Files
Support
Accessories
You may also like…
-
AccessoriesGround fault detector module
-
Battery boxesBattery box 24V FLX M
-
Battery backup accessories
5 Output module
-
Battery backup accessories
2+2 Output module
-
Accessories
19 rack module holder
-
Accessories
19 rack DIN module holder
-
Battery backup accessories
10 Output module
